Brake pads Carbotech or OEM Mazda

2500 pads are a great pad, I dd those and have tracked with them. Carbotech makes great track pads that can be driven on the street, have a set on the Z06 and they take a beating at the track.

Pads: there are lots of options, of course. Generally speaking, the better performance a pad offers, the harder it will be on rotors. I like Pagid a lot, as well as Mintex. Akebono makes some nice ceramic pads that offer no dust and reasonable performance. I prefer a really aggressive pad. Most people underestimate that the pads are your biggest, easiest brake upgrade. My favorite pad is Carbotech. They are out of NC. The panther pad is almost a race brake pad. Constant squealing, lots of dust, and you have to warm them up to get them to work. But when you step on it, you're thankful for seat belts.

I ran carbotechs on my mkV, they are absolutely fantastic for the track. A bit scary on the street totally cold but very livable if you make sure to warm them up.

Back in March I got fed up with the B5 platform shenanigans and started shopping for a Subaru... Upon entering the Mazda dealer, I got the typical \"We don't have the exact one you want in manual, but we do have this...\" and I decided to humor the salesman. Lo and behold, a 2012 Mazdaspeed 3 appeared before me... With 263 ponies and 280 ft/pounds of I could dead, the MS3 has proven itself to be the best possible car that a 23 year old male could own.

I was running Carbotech Xp12s in the front and XP10s in the rear. That and a good fluid is all it needs, but it's a relatively heavy car so it will take a toll on tires and brakes. Also, MDM (stability control) on the competition pack equipped models allows for quite a bit of of slip (yaw) before intrevening, which is nice whether is a novice driver or just wanting to approach the limit in a safer way. Tires are somewhat pricey especially with the 19" wheels, but not excessively so. A set of PSSs will run around $1400. Oil changes, DIY, are about $150 or so. Spark plugs should be changed at about 20K mile intervals. The only problem I had was a bad evaporator for the A/C which was replaced under warranty (book value on the job is about 9 hours). It's a great daily driver, except for the gas mileage and especially the range. It has a relatively small tank and you'll barely get close to 300 miles per tank. That's the most frustrating bit about it. I do wish it had a slightly bigger tank. The sound is great. It's addictive especially with a nice exhaust system (I highly recommend the M Performance exhaust).

However I have Carbotech brake pads, the 1521's for the street and then for the track day I had XP12 (front) XP10 (rear). Pads are compatible with the rotor, and I had the track pads well bedded in.

nobody mentioned Carbotech 1521 yet? they are pricey but work really well for a DD and have low dust.

Carbotech XP10 Front Pads Only - USED - $45 shipped to U.S. lower 48 -these are proper endurance racing pads (popular in Spec Miata, Spec E30, etc), I wouldn't try to use these on the street -used for 2 track days on my '09 TDI -11.6mm of friction material remaining (approx 85%)

Yes forgot to mention mine only started this when switching over to carbotech pads. Stock pads I never saw this issue.

Just had a dealer give me an estimate of $560 for new rear pads and rotors. Unfortunately, the idiot was going by mileage and he never actually looked to see that I just replaced the pads and rotors myself 10,000 miles ago. That was on my 2016 Mazda CX 5.