Brake pads Carbotech or OEM Audi

I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps

XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this

I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.

carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.

I’ve used carbotech XP10 for years because it’s the only pad that has never had any of these kinds of problems. Also also swapped between 1521 and XP10 seamlessly. The only time I had a problem like this was when I used some very cheap rotors that couldn’t handle the track abuse, you could actually see the rotor surface getting pitted. Yours look fine by comparison.

For my GR86 Carbotech XP10s have been amazing on the track, seriously no complaints at all. The XP10s with Castrol SRF have been a great combo and held up really well even on some really big/high speed tracks. I swap in my OEM pads when I’m not tracking the car for awhile. It’s not great because I have to bed the pads every time I change them. Once I’m through the OEM pads I’m going to get the Carbotech 1521’s for the street, that way like you mentioned I think I can avoid having to avoid bedding my brakes with every change. The XP10’s function well on the street but they feel a little rough if not up to temp and they are insanely loud.

I personally use Carbotech XP10 for track and Stoptech Sport pads for street on the same rotors

I had Carbotech XP12 before and they're were great, but squealed like a pig on the street. I haven't tracked the Dynamic Friction but aggressive street even on V730 & daily driving, they've been great.

im running XP10s... so far this set up is amazing, the braking is strong initial bite with little fade. Just take in consideration that this Carbotech pads are modular which means you will have a slight longer pedal travel than normal. And yes they are super noisy, when i drive it on the street i try to be careful with my braking and not feather the brakes, that will make then literally screech and grind the rotors, instead i try to brake a bit harder than usual to get a good bite and then let go of the brake once i stoped (put the car in neutral most of the time or creep forward little by little to releave some heat).

brakes (twice in 26k km, which is crazy stupid - the car didn't get a lot of mileage during COVID, but their brakes are stupid cheap and rust just looking at them when it rains).