Brake pads Brembo or OEM Toyota

Had my Fortuner front pads replaced, Brembo Prime Ceramic Pads: 3500 lang kasama na install sa Jiga.

You can save on the brake pad prices, either buy the original parts from a shop in sharjah for much less or install Brembo Brake pads which also cost much less and are also very good quality.

based on the inputs so far, I have decided to take the Sequoia (price: around $5000, he takes care of the brake pads and rotors.

I swapped front pads with a 13mm socket, hammer and drift pin. In about 30 mins in my driveway. $210, parts delivered from Amazon. Took the opportunity to scrub out calibers free from all the caked on brake dust. Cleaned the inside of the wheels while I was there. Dealership wanted $787 just for the front pads and quoted more than $1000 installed. Easiest job ever and saved $500-$700.

If you DIY and have the tools I did front and rear brakes on my 340i with brembos for $725ish

I have 45k miles on my 2016 STI and just replaced all 4 rotors and pads with another set of Brembos. I don’t drive the car particularly hard and probably could have waited a bit longer but they are done now so I shouldn’t have to worry about them. Cost me about 1k all-in, parts and labor.

I just put some Brembro low met pads on out SQ5. They are more progressive bite, but I like them better than the Hawk HPS 5.0 on my S4. When you get on them they stop very well. Not sure on dust yet.

I recently installed Brembo pads. It cost around £150 for the whole set (1 pair at the back, 2 pairs for the front). But the new ones are day and night difference. It's now super sharp with amazing modulation.

I have the same problem with brembo pads but only when the brakes are cold.The car is breaking good and the noise only last a few minutes. So its ok for me.

This happened to my Gen2. I gave it to some guy to change pads and these lights came out after. I think he didn't do it properly and air entered into the line. I then took it to a local Toyota dealership where they fixed it. (I don't recall what they did exactly, maybe flush and replaced the break fluid). I was fearing it was the actuator, which as other have posted, is very expensive on this Prius. I had to drive very slow and careful, because I had no power in the brakes, so they were hard and slow. No ABS. No regen either.