Brake pads Brembo or Carbotech

Put a light cut on em and a set of Brembo pads and sent it. Good to go.

I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.

I’ve used kits like this before and that one is spot on. I have Brembo discs and pads on my car now, and do notice a bit more bite from the pedal this time, which is amwbag I was looking for. The downside is the brakes need a bit more heat in them before they’re effective, which is not the case with the Sebro/Textar setup.

I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps

XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this

I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.

carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.

Brembo sind meiner Meinung nach nicht mehr das, was es mal war. In meinem Mazda quietschen die schon ordentlich, wobei die OEM das auch tun.

The oem brakes on my 2012 were lackluster and kept seizing pins or calipers so I fixed the problem for good

Used Brembo pads on my 535d, then gave them another try on my i30N. Will never buy again. Suitable only for casual, calm driving around the city. Overheat very easily, overall stopping performance got worse, brake pedal feeling became harder.