Brake pads Bosch or OEM Toyota

I just put Zimmerman rotors and Bosch pads on my front end for ~$400. Worth every penny.

Check Rockauto. I replaced my brakes about 2 years ago with Dynamic Friction Geospec coated rotors and Bosch quiet cast pads. Still in great condition and stops on a dime.

I run a fleet of Camrys and use Toyota pads because I've found that they produce the least brake dust and I HATE dirty wheels.

I bought my 2016 Prius used with 32k miles on it back in 2019. It now has 157k miles and the maintenance has been a breeze. Just standard oil changes every 5k, 1 transmission fluid change, two sets of tires and I don\u2019t even think I have replaced the brakes yet ..no seriously I don\u2019t think I have yet.

I went with Bosch pads this time on OEM rotors.

I swear by Bosch quietcast. I’ve done cheap brands before but seem to squeak, fade, or make too much dust.

Bosch brake pads are good for me in my performance pack.

Rear brake pads and rotors will not have an effect on nor cause a master cylinder failure.

$500 for a wheel alignment and new Bosch pads on all 4 wheels. Car is a 2010 Cruze.

Bought a 2012 Toyota Sequoia from Heritage Motors on Shore Drive with a fresh inspection on it, So I personally figured it'd be solid, as Sequoia's are known to be pretty dependable. Not only was it a lemon/some huge issues, but the brakes were slapped together with bubble gum and hopes and prayers. The brake pad on the passenger side was installed backwards, which I was shocked it didn't make noise on the test drive