Brake pads Bendix or OEM Mazda

OEM Mazda Brake pads
LegionVR6
  • Braking:
Rating 4.0

2016.5 CX-5 with 89,000 miles. So far I've had to replace the belt tensioner, accessories belt, water pump belt and breaks (technically I only needed pads and front rotors but I chose to just do them all in one shot since it made a negligible price difference since I was already doing the back pads.

Pros: cheap replacements
Vehicle: Mazda
Mileage: 89000 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads
Kristianf00
  • Braking:
  • Noise:
Rating 4.0

At 55,XXX miles and still haven’t changed my brakes on 2019 AWD Mazda 3(not as heavy as yours but heavier than a FWD 3) Last service, I was in the green for both sets still, but they said I would likely be in “yellow” by 60-65k. I did want to note—I hear no scraping/squealing and brakes feel relatively strong just not as great as new.

Pros: brakes feel strong
Cons: not as great as new
Vehicle: Mazda 3
Mileage: 55000 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads

2015 sedan. I did my brakes last spring. I went with OEM as I found them cheaper than any aftermarket I could find near me and as far as I knew I still had OEM on my car and had lasted me a long time. Zero issues since having them installed, I’m happy.

Pros: zero issues, long lasting
Vehicle: Mazda 3
Comment
Is this review helpful?
source
Bendix Brake pads
JPKaliMt
  • Braking:
Rating 5.0

I use bendix on my truck and love it. I figure if they make good pads for the big rigs I work on, why not run them on my truck?

Pros: love it, reliable
Comment
Is this review helpful?
source
OEM Mazda Brake pads

i remember hearing a guy complain about his cx5 eating through brakes, but the cx5 is the same car as my mazda3, and my mazda3 has seen 70,000km for its rear brake pad/ 90,000km for the fronts, and I drive a mix of city/highway.

Pros: 70,000km rear brake pad
Cons: cx5 eating through brakes
Vehicle: Mazda 3
Mileage: 70000 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads

My cx9 was at 3mm on the rears at 52k. Get a caliper compression kit and it yourself. It's not very hard. I did my rears a month back in my driveway for $130.

Pros: easy DIY repair
Cons: rear pads worn at 52k
Vehicle: Mazda
Mileage: 52000 km
Comment
Is this review helpful?
source
Bendix Brake pads
oldskoolsr
  • Braking:
  • Dust:
Rating 1.0

I had Bendix GCT on my cars. Lakas nya kumalmot ng rotor discs nyan that i now need to reface the discs on the yaris. Yung e90 ko is in need of refacing na din dahil sa bendix, ginagasgas nya and rotors. Also produces a lot of brake dust lalo na white wheels ko kita agad.

Cons: Damages rotors, excessive brake dust
Comment
Is this review helpful?
source
OEM Mazda Brake pads

Mazda brakes are notoriously shit. They’re garbage. Buy a set of PowerStop brakes and be done with it. They’re far superior to the Mazda brakes. Go on any forum and you’ll see countless people having the same issue as you. New brakes between 15-20,000 miles. Me included. I’ve owned 2 6s from new. Both needed brakes around 20,000 miles. Both times I put on PowerStops and never had another issue.

Pros: PowerStop superior, no more issues
Cons: Mazda brakes garbage
Vehicle: Mazda 6
Mileage: 20000 km
Comment
Is this review helpful?
source
1 ... 4 5 6 7 8 9 10 11 12

Write your review

Help others - share your experience with this part.

Other comparisons
Loading...