Brake pads Bendix or OEM Mazda

I got about 107,000 on my 06 and haven't needed to change the rotors yet. I just use Bendix Ceramic pads front and rear, we have always used Bendix stuff and never had any issues.

Back in March I got fed up with the B5 platform shenanigans and started shopping for a Subaru... Upon entering the Mazda dealer, I got the typical \"We don't have the exact one you want in manual, but we do have this...\" and I decided to humor the salesman. Lo and behold, a 2012 Mazdaspeed 3 appeared before me... With 263 ponies and 280 ft/pounds of I could dead, the MS3 has proven itself to be the best possible car that a 23 year old male could own.

After 217k on my 93 Eurovan I am still on my original rotors. I do change pads every 35-40k usually Bendix

On a positive note- the brakes were sporty car firm and easy to modulate even with these tires.

oh and i replaced my craptastic wagner thermoquiet pads with bendix pads much better feeling on the pad and the calipers dont seem to get so hot

Bendix Titanium pads with new rotors 4/20/02

I put in some new rear brake pads today. The frist brakes I had were Autozone brand. Well, they went on fine on the driver side. On the passenger side It was near impossible to push the piston back far enough to get the pads on. I still needed about another 1/16th of an inch. I even bled brakes a little to make room for the piston compression. Still no luck. So I went back and bought some Bendix that were about 1/16th less in thickness. So, I put them on the passanger side. I had to wrestle with the piston again - that mofo would not budge. Finally I got it. So, I go for a drive with Albany brakes on one side and Bendix on the other. A horrible scaping erupts from the driver's side. The side that went on much easier. Visual inspection looked ok. So I took them off and they were all scraped to heck. Strange, as that was the easy side. So, I put the Bendix pads on that side and everything is fine.