IMO, Akebono Ceramics are the shiz. I had some on my Audi A4. Way better than stock, very little dust to clean off, and you can just get them off Amazon for less than OEM.
Like the previous comment said, akebono is their oem supplier, imo I like raybestos the best because they’re super cheap on rock auto and they produce a lot less dust if you go with ceramic pads instead of metallic
Akebono is the original equipment manufacturer of brake pads for Honda.
I have Raybestos Element 3 pads on 2 of our 3 cars and brake dust is next to nothing.
I use Akebono brake pads. Little expensive but it's the best
I recently replaced front and rear pads and rotors on my 2021 CE TURBO with Raybestos EHT3 pads and element 3 rotors (rear) and Raybestos specialty performance rotors (front). I'd highly recommend them. They stop a little better than stock and handle heat a lot better. The rotors are also fully coated and don't rust. They've been 100% quiet and feel great.
My wife's Cabriolet has Akebono pads, front and rear. Pedal is firm, stops fine.
Last point since you're doing brakes, I'll plug Raybestos Element 3 pads and rotors. Installed them on my wife's car last year and I'm genuinely impressed at the braking response in her car.
Raybestos Brake Pads - SGD924C - $25 obo
I just put on Akebono ceramics and Zimmerman coated rotors and I hated them for the first few hundred miles. They took a very long time to break in, and this was after a) paying attention to the instructions that say no break-in is needed and b) ignoring that advice when the stopping distances were so bad initially that I bedded them in... and yet the pedal effort was so high that I could barely engage the ABS in the dry. So I'd recommend staying away from that combination.
Write your review
Help others - share your experience with this part.
