Brake pads Akebono or OEM BMW

Recently did a brake change on my 14 Q50S AWD, pads and rotors (Akebono) for front and rear for regular maintenance. After the change I did the same break in technique I’ve done with all of my vehicles and all was well.

akebono pads are amazing. try them, you wont regret it one bit.

Use Akebono ceramic pads. They have like 5% less bite than the performance pads but last way long and produce wayyyyy less dust. In emergency situations the grip is limited by your tires, so that 5% performance loss isn't really worth anything for daily driving.

Best things I did for my g80 was 1) Mishimoto skid plate to protect my oil cooler 2)Ceramic brake pads because the red dust that will engulf the lower half of your car after a 1/2 mile drive is insane.

Akebonos are a good, quiet, low cost, and low dust option for the street. They also get rid of the annoying "bite" that the original pads have. They're a much more progressive pad. Don't try to track them though.

Akebono has had the best blend of low dust low noise and good initial bite. I’ve used hundreds of different pads at my shop over the 14 years it was open and they were consistently the ones that had the least amount of problems.

I've also been using Centric 120-series brake rotors and Akebono ProAct ceramic pads for years. The pads are long-lasting and amazingly dust-free.

I would look at pads. Akebono which are a low dust pad act like what you are experiancing. Not a lot of inital bite. Which I like.

2001 740i never had any issues with the throttle response but the brakes could be better. Too spongy and not as responsive as my 99 540i was.

I would stay away from ceramic Akebonos. Out of all ceramic pads I tried, they felt the most dangerous. They had close to zero initial bite and required three times the leg effort to brake.