I've been running those pads for a while now, not only do they feel and stop just like OEM unless you're a person that tracks the car, but they also keep your wheels clean longer. The amount of reduced dust is staggering. No other noise, I've never had them squeal, even when needing to be replaced.
Recently did a brake change on my 14 Q50S AWD, pads and rotors (Akebono) for front and rear for regular maintenance. After the change I did the same break in technique I’ve done with all of my vehicles and all was well.
Pads (Ferodo ds1.11 is what i started out with)
akebono pads are amazing. try them, you wont regret it one bit.
Use Akebono ceramic pads. They have like 5% less bite than the performance pads but last way long and produce wayyyyy less dust. In emergency situations the grip is limited by your tires, so that 5% performance loss isn't really worth anything for daily driving.
Akebonos are a good, quiet, low cost, and low dust option for the street. They also get rid of the annoying "bite" that the original pads have. They're a much more progressive pad. Don't try to track them though.
Akebono has had the best blend of low dust low noise and good initial bite. I’ve used hundreds of different pads at my shop over the 14 years it was open and they were consistently the ones that had the least amount of problems.
The 3.12s have a LOT of bite and can make modulation tough on certain cars. On my E46 M3, I run DS UNO or DS1.11s. That's with the AP race kit front & rear. Didn't like the 3.12s for that application.
I put on Akebono pads and Raybestos rotors about 500 miles ago. Super squeaky with light brake pressure; I'm at the point I want to pull them apart and clean it all then reassemble.
I replaced my brakes with Akebono. But I am not going to buy it again.
Write your review
Help others - share your experience with this part.
