Brake discs Zimmermann or OEM Volkswagen

Rallye 1.8T you are the man! Thanks for the tip and saving me a lot of time and money. The mk5 312x25mm rotors work on my setup. Only thing I have to do is run one thin washer between the bracket and spindle.

I just bought new brake discs for all four corners. They are made by Zimmermann, a pretty reputable aftermarket supplier. Cost was about half of the OEM.

While I understand the need to be frugel, you're talking about the most important safety equipment on your car. IMO this is where you don't cheap out. I just bought a set of Zimmerman replacement rotors (fronts) and a set of PBR Deluxe pads for under $200. Like the old Fram advert said... 'you can pay me now, or pay me later'.

Zimmerman front rotors with ebc pads. Stainless braided brake lines on all four corners and ate super blue brake fluid.

I had the car in at the dealer on Saturday morning. Spent about 3 hours there. The service guy took it and had the front rotors replaced. They agreed there was quite a bit of shake in the steering wheel. All in all, good experience.

If VW won't cover the costs, then don't buy the VW rotors again. Tire Rack sells Centric brand rotors for our vans. These are the same rotors that Powerslot rotors use, just without the slots. They are about $50 each are a much better quality than the stockers. Yeah it's $200, but I would bet these will not warp like the stock rotors.

Btw I'm throwing in : 4 16x7 et45 Genuine Votex wheels 4 205/55/16 Kumho HP4 716 All Season Tires (Great for Winter Setup) Votex replica sideskirts Lots of Misc parts like resurfaced Audi A8 Zimmermann rotors, Front PBR deluxe pads, etc...

They are slightly better tho because the rotors are bigger, hence better stopping power but all that has already been discussed up top. I just want alittle quicker braking and nicer looking calipers.

Zimmermann rotors are made in Germany, while Brembo rotors are made in Italy....... how would they pull that off?

Unfortunately the problem is inherent in the design of the rotors. Not in where they were produced. You can put the best rotors in the world on that car and they will still warp. Vw/Chrysler would need to spec a larger and thicker rotor to help dissipate heat properly. All aftermarkets will make the rotor to fit, based on the crappy oem specs. So, get used to having new rotors put on...because recall or not, Chrysler still needs to redesign that rotor. FYI, I'm in the same boat as you guys! These rotors suck!