Brake discs Zimmermann or EBC

I went with Zimmerman rotors and oem pads on my M340i. Perfectly happy with the cost savings over the oem rotors.

You mention cost but not weight differential of the rotors, many people move to girodisks because it reduces the weight at each corner. With regards to blanks vs drilled, I have had no issues running drilled (Zimmerman) on my previous Audi TTs and my current 718. I run a dedicated set for track with Carbotech XP12s, no fade, no issues. 718 is in roughly the same weight category, 3k ish.

I had my V60t6 2020 done for 800$ with Zimmerman rotors and Hawk pads (high performance). The job was done by 2 technicians within 1h.

Solid, Zinc coated Zimmermann with Red Stuff pads. I'm stage 1 and push my car a bit occasionally and have never had any issues stopping when I want to.

I replaced my previous rotors with Zimmerman ones and they also had this notch so don’t worry about it as it’s normal.

I used Zimmerman rotors and ATE ceramic pads all purchased from fcpeuro.com. With stock pads I could wash the car and within two days they would be brown from brake dust. Now I can go weeks before I start to notice that there may be a little dust.

With the ceramic pads I cannot tell a difference in braking, I have almost no brake dust, and the rotors still look like new.

I use ebc slotted rotors with red stuff pads for my dailies

I used both before Zimmerman is good and cheap. Akebento are good too but hard to find and more expense. I practically used all brake pads and rotors over the 13 years I own the RRS. I would recommend using cermpads.

i run ebc front rotors, dba rear rotors and powerstop pads brakes good but my fronts squeal when cold (my car has brembo calipers)

I’m getting issues with rotors warping on my 2002 E53. I bought Zimmermann smooth rotors couple of years ago and they’ve been lathed couple of times now. At one point I had to replace Zimmermann pads too as they were excreting glue or something that caused “falling stars” on the rotor faces.