Brake discs Zimmermann or DBA

I was recommended Zimmerman Rotors for my 550i by a bmw shop and I've really liked them so far. I've had them on for the past 4 yrs and never had an issue. I bought some autozone rotors once before that warped and rusted super quick.

Run DBA on my R32 GTR. Lot of Autobahn shenanigans and terrorizing small twisty village roads.... they're great!

I have DBA T3 rotors on both my 350Z and R34 GTT, I\u2019ve never had an issue with them.

I have DBA rotors all around on my BCNR33 and they are wonderful.

DBA is fine as an upgrade, can highly recommend Stoptech as wel. If combined with PFC pads (not too agressive, I think .9 or .10/.11 compound) and new brake fluid + braided lines it feels so much better and safer.

Rear Rotors (Zimmerman) and Pads (Jurid) with break Sensor

I installed some new brakes and after looking at all the options I went with FCP’s bundle of Zimmerman drilled rotors and EBC red pads. I’m normally not a fan of drilled as my first set of drilled rotors back in 1996 warped and since then I’ve gone with just slotted. Since the mass is so great on the 345mm rotors I felt there would be enough mass to stay true/straight. FCP’s lifetime warranty helped seal the deal on these brakes.

I have been using ATE pads and zimmerman coated rotors. last time they were replaced i bedded them in with a few hard stops from 60mph.

I'm running their sport pads with Zimmerman cross drilled rotors. The Zimmerman rotors are significantly cheaper for the same consumable. Very happy with my setup and I would repeat it in the future

I've used Zimmerman + ATE combos on my ... for daily use. They are totally fine. Good stuff. Couple weeks ago I wanted to try something different on the R so I got stoptech slotted and EBC red. They feel good so far. Hopefully low dust.