Brake discs OEM Toyota or OEM Volkswagen

Rallye 1.8T you are the man! Thanks for the tip and saving me a lot of time and money. The mk5 312x25mm rotors work on my setup. Only thing I have to do is run one thin washer between the bracket and spindle.

I had the car in at the dealer on Saturday morning. Spent about 3 hours there. The service guy took it and had the front rotors replaced. They agreed there was quite a bit of shake in the steering wheel. All in all, good experience.

If VW won't cover the costs, then don't buy the VW rotors again. Tire Rack sells Centric brand rotors for our vans. These are the same rotors that Powerslot rotors use, just without the slots. They are about $50 each are a much better quality than the stockers. Yeah it's $200, but I would bet these will not warp like the stock rotors.

They are slightly better tho because the rotors are bigger, hence better stopping power but all that has already been discussed up top. I just want alittle quicker braking and nicer looking calipers.

i have been told at the dealer that new thickness is approx 25 mm, and replacement size is 23 mm... VW recommends they be done together, but backyard experts & penny pinchers feel that it isn't necessary...... I would never take a chance for the $200 or so that rotors cost it just isn't worth it. if you can't afford $200 for the most critical safety system on your car, perhaps you should take the bus until you can... Very small diameter diferences cause degradation of brake performance, witness when the pads are half worn how low the fluid goes down....that is compensating for the pad wear and ROTOR wear as well......tires & brakes are all that saves your butt in the day-to-day world of insanity out there, don't be foolish.

Contrary to what some people think, the rotors are designed to be replaced when the pads have fully worn down. The tolerance for allowable thickness on our rotors is very small. I don't know the exact number off the top of my head, but IIRC the front rotors on your Jetta are 25mm thick when brand new and the minimum thickness is 23mm. That's not a lot of wiggle room. When the pads are fully gone the rotors will be very close to minimum thickness. You can mic the rotors to test the thickness, but made sure you get past the \"lip\" on the very edge of the rotor or you will get a false reading. Personally, I say don't mess around with brakes. If you only have a few thousand miles on the rotor, than fine - keep it. But if the pads are gone, the rotors are gone too. On a somewhat related note, I just did the brakes on a 2006 Mini for a friend of mine. The tolerance between min and max thickness was only 1.6mm on the front rotors! That's tight.

It was brought in by another shop that installed rear brake pads and rotors.

Many heavy 4WD vehicles out there chew through rotors in 25k miles. My LandCruiser goes through them every 20k. And yes, I have checked the thickness and I've tried resurfacing old rotors a couple times but it always resulted in short life and problems.

The cause is Sub-Standard, Cheap "Made in China" Rotors.

You know.... I thought I was immune to the brake issue on the Routan until about 3 hours ago. Was on the freeway and had to brake somewhat hard for traffic. And there it was.... very noticeable shake of warped front rotors. 9300 miles on it. I am super light on my brakes. Almost all of my driving is freeway driving. These rotors are clearly crap.