Brake discs Brembo or Zimmermann

I went with Zimmerman blanks and Hawk HPS pads (non 5.0), been very happy with them.

I went with Zimmerman rotors and oem pads on my M340i. Perfectly happy with the cost savings over the oem rotors.

You mention cost but not weight differential of the rotors, many people move to girodisks because it reduces the weight at each corner. With regards to blanks vs drilled, I have had no issues running drilled (Zimmerman) on my previous Audi TTs and my current 718. I run a dedicated set for track with Carbotech XP12s, no fade, no issues. 718 is in roughly the same weight category, 3k ish.

I went with: Brembo rotors all around 288mm front and 232mm rear Tyrol Sport Front Brake Stiffening kit DFC track pads(similar to Hawk HP) I still need to do SS lines and a fluid change, but my car stops very well for street driving. I will be swapping my pads for Hawk Performance Ceramic's though only due to brake dust.

I had my V60t6 2020 done for 800$ with Zimmerman rotors and Hawk pads (high performance). The job was done by 2 technicians within 1h.

Solid, Zinc coated Zimmermann with Red Stuff pads. I'm stage 1 and push my car a bit occasionally and have never had any issues stopping when I want to.

I replaced my previous rotors with Zimmerman ones and they also had this notch so don’t worry about it as it’s normal.

Just bought some brembo rotors and pads for the front. Oil filter and a rear windscreen wiper blade for $289 AUD.

I’ve been using Brembo for my E39. Just be careful that there are lower tier for Brembo, it is still original Brembo but without anti-corrosion coating. It got corroded after a month or so. The one that got coated is slightly more expensive but I’d go for that next time.

I put cheap rotors in the front. They suck and made braking unpredictable and dangerous, especially from 150kmh plus. I bought Zimmermanns a week later and the problem completely vanished.