Owner reviews for fuel injector

The longitudinal 1.8T's runs out of injector pretty quick so if you start pushing your current turbo you may need them anyway - hopefully you can log your injector duty cycles (or have already) to see where you're at.

Holy ****, they fit. FOUND IT. The injector that has been so elusive that flows more than stock (exact % will not be disclosed at this time as I do not want to upset any advertisers with my findings....) is from the GM 2.0 Ecotec motor: - GM LNF 2.0 ECOTEC OEM Injector Part # / Bosch Part # : 12636111 / 0 261 500 112.

I finished installing a rebuilt fuel injector and water pump in my truck yesterday. It was warm yesterday afternoon when I finished the job, and when I started the truck it ran fine and there was no smoke.

Brand new timing belt (run idling) Turbo K03-001 (brand new run just idling) Bosch 386CC injectors (brand new run just idling) MS2 V3.56 MANAGEMENT EQUIPMENT MEGASQUIRT OEM clutch kit 2 1/2 intercooler piping with front mount 3\u201d turbo back exhaust (side exit) Audi TT conversion Fron Brake kit rear disk brake conversion kit Audi TT Master cylinder , brake booster, and brake lines Full mk4 tranny swap with Hidraulic Clutch Eurospec fuel pressure regulator K&N Monster Filter NGK BKR7 Spark plugs Dinomax exhaust 3\u201dx3\u201d HKS SSQV Blowoff N75 Race valve

DIY: a complete guide to convert your chipped 1.8T to run on E85 FlexFuel ethanol (4ceFed4) STEP 2: Siemens/Deka 630cc Injector Swap

It's been a bit expensive to maintain compared to the other dub's i've owned though. at about 117k miles now, and since i replaced the PCV, DV, Coilpacks, Cam, HPFP, AC compressor, injectors and hand-picked the carbon deposits out, (all out of warranty and on my dime) it's been great!

I'm on my second fuel injector at 92,000 miles....i have a chip GIAC.....don't know if my stock injectors are getting worked O.T. but it is what it is i still enjoy my VW DUB.

Literally today my I was driving my Mk6 GTI and all of a sudden it felt horrific to drive, properly lumpy and then the EML and EPC light came on. Managed to limp it into a car park about 500m down the road. I read the code and had P0303 Cylinder 3 Misfire.

Swapped the coil from cylinder 3 into cylinder 2 and cylinder 3 was still misfiring, indicating that it’s the injector at fault and not the coil.

He said it was a sticky injector as it was running like shit and loads of white smoke, indicating unburnt fuel, was coming out of the exhaust.

Up until a little over 45k miles, I was impressed that nothing had gone wrong. Then a little while back, it started to get a misfire. It was discovered that one of the fuel injectors needed to be replaced. That was a fairly expensive repair especially for a car with such low miles.

I took out the injectors and got a good look at them and they were gummed up, carbon caked and in horrendous shape, their spray patterns were like a straight stream. It was obvious at this point that they were the culprit.