Reviews of VALVOLINE parts For Business

I have been using various Valvoline synthetic oils 10+ years in multiple stationary engines, tractors, diesel and petrol engines. No sludge, no varnish inside the engines, and never worn an engine out.

I use Valvoline restore and protect. It fixed the tick after a few oil changes

5W30 Valvoline Restore and Protect is good

Valvoline Restore & Protect is reportedly great.

I run Valvoline restore & protect because 2x 5 qt jugs fits my 4 qt Prius and 6 qt Maverick perfectly and I run it on the Prius which has stopped oil burning from the low tension rings.

Valvoline has their hypoids available in handy-dandy squeeze to dispense bags that let you fill the case up without spilling anything.

Both of my Guzzis ran better on Valvoline. This is if you’re in USA

I'm using Valvoline 0W-20 Restore and Protect, changing every 4,000 miles. '23 OBW, 56,000 miles. FYI, I did an oil analysis at my last oil change. Wear numbers were excellent, less than 1.5 ppm/1,000 miles. 3 iron, 2 aluminum, 1 copper over 4,128 miles. Fuel dilution was HIGH though, at 4.3%. They expect 1.5- 1.8% for direct injection turbos. According to the Motor Oil Geek, less than 5ppm/1,000 miles is considered good. I do a fair number of short trips, but also some longer runs. I'm going to go to max of 4,000 miles due to the gas dilution.

Nissans are hard to read too. Valvoline always shows me the stick and I can barely see the proper fill level. Car is usually fine.

I do believe that Valvoline R and R can cause oil leaks. I have noticed that in a couple of cars.