Reviews of OEM Volkswagen oil filter

Original owner of a mk6 R here :wave: my R has ~50k miles on the clock. lightly modded (see sig) and I have never had any issues other than normal wear stuff. plugs/oil/filters u know. car still feels very close to new.

I have purchased a new genuine plug, crush washer and oil filter and plan to change the oil and parts together

I just changed the oil on my TDI at 15,000 miles and when I pulled the engine cover it looked factory fresh under the cover. Meaning there was no evidence that the dealer even made an attempt to change the cartridge filter. I was very, very careful not to spill oil on the engine components but still managed to get oil on the white mesh heat shield next to the filter housing. When I removed the cartridge filter it looked extremely dirty and gunky.

I used the bigger passat 1.8t filters on my DD 2000 jetta with mobil 1 0w40 for over 100k in 4.5 years (135k total on vehicle) and when that car was totalled in a flood, the motor was tight and flawless...

Oil filter/housing and the Crank Position Sensor are pretty common leak points. The CPS leak on my own car was like this phantom leak I just couldn't find until a shop fixed it for me.

oil filter that i run is off of a 1995 Eurovan Part # 074-115-561 hold about 1qt in the filter itself. had to slightly bent the secondary air pump a tad so it wouldnt rub.

my 5k service on Friday, w/oil change, cost $54 w/filter (I supplied the oil since the dealer didn't stock it, from http://www.1stvwparts.com / for $6.80/ltr.).

I used the oil that is VW507.00 spec and can be bought at the VW dealer (approx retail cost is $7.00 per liter) Oil change capacity is approximately 13 liters. Oil filter part number is shown. I ordered the oil filter cap removal tool from http://www.samstagsales.com for $67.00 plus shipping.

yeah the oem ones arent (THAT) expensive and they work great.

Pros - They have a real oil filter, the case is sturdier, they can handle more power and bigger displacements, they last forever without machining, the stock heads were pretty solid. Cons - They are harder to work on since there is more to assemble and disassemble, parts are slightly more expensive (not much though), they are harder to find, the different year engines had many variations so you have to know which one you've got.