Suzuki Swift parts reviews

Castrol mangnetec gave me good performance but in city conditions it gave inconsistent fuel economies for me and under normal cruising speed 80-90 it performed really good. But for me it felt like reaching higher speeds above 100 felt slower compared to shell. Initial pick up of my car felt higher with this oil.

Am ales Bridgestone pt performanța pe uscat și ud, dar cel mai balansat este SF3. Bridgestone e pe un Suzuki Swift 4x4, Hankook a fost pe Sandero Stepway.

sailuns are great! especially the attrezo elite. yun yung sinalpak ko sa suzuki swift ng kapatid ko. changed how that thing drove (albeit she ran the previous tires to the cords) to the point i actually was genuinely surprised how night/day the difference was especially with soaking up bumps.

Swift petrol 2017 model with AGS. The OEM Exide battery lasted until 2022 (5 years). I actually ruined the OEM battery by overfilling it with distilled water ????. Else, it might have lasted longer. Got a Bosch battery after that and it's still running with no issues.

I get mine for my AZ swift sport from RHD Japan. 3 track days and no fade etc. no squealing. A bit of dust. Endless CCrG. If you’re not tracking it then get Endless MX72+ Or Project Mu HC+ Locally you may be able to get EBC yellow stuff.

In my experience, Yokohamas last the least amount of time. Had a set of 205 advan fleva v701’s on a Suzuki swift sport and it was glued, for a brief period.

Matagtag talaga yung swift kahit naka KYB New SR.

I switched to the Ferodo DSUno. I am satisfied with its performance, but they seem to struggle because of something. Today, after the track day on Saturday, I checked it and found a crack and a gnawed edge. Also, they have uneven wear, about 0.5-1mm difference. The differences are between the top and bottom parts of the pads, front and back parts and on different sides of the same rotor (inner and outer pads). Uneven wear was with the old pads as well. Recently, I installed brake air ducts, and after going out from the track, the temperature was, in the worst case, 480C degree, which looks fine for these pads. In total, I drove for about 3 hours on tracks, one on a wet track (so no hard braking) and two moderately/hard(8-9/10) braking. The brake rotors are also new, Zimmermann blank, installed with pads. The initial thickness of the pads is 16.4mm (with the plate, the plate is 5.5mm, so the "pure" pad is about 11mm) Currently, I have eaten about 4.5-5mm of the pads in 3 hours of tracking.

I had a track day today with 1 hour session and closer to the end they were fade.When I took the pads out to check I noticed that they are extremely glazed like covered with a melted metal.Also, looks like they covered rotors with this melted metal, the inner side of both of them.The outer rotors surface is fine. The outer pads look the same glazed.I was checking them yesterday last time and they looked fine.The friction material looked fine and not that glazed.It's on the last photo.I was trying to brake short and strong all the time.There car is Suzuki swift sport.Brake pads ferodo dsuno.Track Zolder.

Took the Swift for a spirited drive down the horseshoe pass today, by the bottom the brakes stank, pedal went soft and stopping power became dangerously weak. Drove it softly for a mile or so and they were back to normal and I could lock the wheels again.