Thermostat MOPAR or MISHIMOTO

MOPAR Thermostat
Flowermomi
  • Slow warm-up:
  • Overheating:
Rating 5.0

I had the same issue and throwing a bad thermostat error code. I had the thermostat replaced and it kept happening. He said the thermostats out there are crap and they’ve had to change some 3 times. He did recommend getting a Mopar thermostat if I could. It was replaced and I’ve had no issues.

Pros: no issues
Cons: kept happening, thermostats are crap
Vehicle: Jeep
Comment
Is this review helpful?
source
MOPAR Thermostat
Emergency_Ad7766
  • Slow warm-up:
  • Overheating:
Rating 5.0

The OE version is the only one that works. Knock off t-stats will generally last a few weeks to a few months. The OE thermostat has been updated, pops at 203 degrees and lasts much longer than anything else. An OE thermostat seems to fail open. Whereas the knock-offs fail shut.

Pros: lasts much longer, fails open
Cons: last a few weeks, fail shut
Comment
Is this review helpful?
source
MOPAR Thermostat
used-user001
  • Slow warm-up:
  • Overheating:
  • Cabin heat:
Rating 5.0

Finally got around to replacing the thermostat on my 2000 XJ. Temp rarely hit 210 unless I was idling for a while so I suspected a bad thermostat. Sure enough it was stuck in the open position. I was able to find an OEM one part # 5202 8186AC. 195 degree with a weephole. Noticeable difference in performance and it’s nice to have heat again.

Pros: improved performance, restored heat
Part number: 5202 8186AC
Comment
Is this review helpful?
source
MISHIMOTO Thermostat
EnKryptedToast1
  • Overheating:
Rating 3.0

I wanted to upgrade from plastic and got an aluminum Mishimoto thermostat, but i didn’t notice that it opens at 180°. Can i get away with the 180° thermostat, or should i ship it back and re-order a different, higher rated thermostat?

Pros: aluminum, upgrade from plastic
Cons: wrong opening temperature
Comment
Is this review helpful?
source
MISHIMOTO Thermostat
_-heartless-_
  • Slow warm-up:
Rating 0.5

when installing a mishimoto thermostat, check that the shoulder/flange is the same thickness as oem. Otherwise your stock hardware WILL NOT FIT. You will bottom out the bolt in the timing cover and snap that mf. Those bolts are extremely hard to access and a MAJOR HEADACHE to get extracted.

Cons: incorrect flange thickness, hardware fitment issues, difficult extraction
Comment
Is this review helpful?
source
MISHIMOTO Thermostat
Manny1693
  • Overheating:
Rating 2.0

mishimoto changed the design of the thermostat when I purchased and you will need shorter bolts they are not provided

Cons: design change, bolts not provided
Comment
Is this review helpful?
source
MOPAR Thermostat

I had a very similar issue. Radiator and Thermostat replaced after accident. 2014 WK2 3.6 V6 was overheating when I drove up the mountains in Colorado. The problem was the mechanic put a Napa thermostat in, then replaced with another napa thermostat. I bought a MOPAR thermostat and swapped it myself.

Pros: easy to replace
Cons: overheating in mountains
Comment
Is this review helpful?
source
1 2 3 4

Write your review

Help others - share your experience with this part.

Other comparisons
Loading...