Oil filter Mahle or OEM Mazda

I own a f30 (330d) and have done my own oil changes for the past 9 years and change oil every 7k miles. I started out using 0w-20 oil till around 60k mileage. I then switched to 5w30 from 60k mileage for engine longevity. I’ve always used Mahle filters on my car. Mann and Bosch are good alternatives to use too. As my F30 sits quite low I have always jacked it off the ground so I can get access to the sump plug. Also remember to change the washer from the sump plug during every oil change.

4,6 Liter LM TopTec 4200 (Gebinde von 5 Litern ca. 40 bis 50 Euro), Ölfilter Mahle OC456 ca. 13 Euro, Dichtring für die Ölablassschraube

Mazda recommends their oem filters on skyactive motors. Its because they dont have the flaps that keeps oil pressurized. Any wisdom says you dont need it but go ahead and buy them online as I paid $5 per.

In terms of filter and oil, I have an NA and I personally like to buy the OE filters from Mazda and for oil I just use the oil recommended in the owners manual, id assume the ND uses different oil so I’d say just check that.

I had an e90 with the n52 engine. When i first got the car i installed a Mahle filter that fit. After a bit of driving the engine started making weird noises, similar to vacum leaks. And I did som research. Apperantly my experiance was common with "aftermarket" oil filters. Switched to Mann filter on my next oil change, specificaly the same variant as the right one in your picture. The problem disappeared instantly. Also the Mahle filter had kind of colapsed in on itself.

I have no problem with using a Bosch, MAN, Mahle as long as it’s a good brand.

YES! My 2012 Skyactiv is at 233K miles, and has always had the Mazda Moly 0W-20 (with the exception where I was able to get the Idemitsu version, which is the same stuff, but without Mazda's markup. Sucks that it isn't available anymore. ) and I'm not about to chance running a different oil.

Always run a Mazda filter too. The quality seems better than most.

I use OEM Mazda filter. Synthetic oil, Kirkland brand or Castrol since i think thats who makes the Mazda oil.

and don't use store bought oil filters unless they sell Mahle or Mann.

After an oil change, the car shot most of the oil out from the filter. I installed a brand new Mahle filter, tightening it snug. After a short drive, it again shot all the oil out of the filter, with the gasket forced to the outside.