Engine oil OEM Mazda or OEM Audi

Definitely prefer the extractor here! So easy/clean and gets all of the oil. At least in a Q8 and b9 A4/5 it got everything

I’ve done both and extractor takes out like 97% of oil. I still had about a half cup when I pulled the plug.

For Naturally-Aspirated Skyactiv engines, it is highly recommended that you use Mazda's own(Idemitsu) high molly GF-5 0w-20. Arguably it is one of the best oil for skyactiv engines.

But then we replaced it with a SkyActiv Mazda3 that used 0w20 and proceeded to have a good long history with that motor that had 0 oil consumption in 125K miles; I did all of the oil changes myself and it was always 4.5qts in/4.5qts out every 5k miles.

For [Naturally-Aspirated Skyactiv engines](https://en.wikipedia.org/wiki/SkyActiv), it is highly recommended that you use Mazda's own(Idemitsu) high molly GF-5 0w-20. [Arguably it is one of the best oil for skyactiv engines](http://www.cleanmpg.com/community/index.php?threads/45295/#post-357910).

2014 3, 0W-20 full synthetic (whatever major brand is cheapest) from brand new, every 7500 miles.

170k, runs like a top, burns not a single drop between changes, compression and fuel mileage exactly the same as new.

I use Mazdas 5w-30 Ultra DPF. Mazda once said that this was the oil that they're using, so I guess what's used by mazda can't be too bad for the rex

I had the same issue on my 2019 A6 3.0 last year. Two times I had to pop into the dealership to have oil removed (no charge) and the issue was due to dilution and short trips.

Many reputable rotary shops have tested numerous oils over the years, and agreed that the bearings do not have adequate protection with 5w-20 or 5w-30, especially if you track the car or do any spirited driving regularly.

they only say you can do that with their Mazda-branded oil. That stuff tends to be expensive.