Brake pads R1 Concepts or OEM Chevrolet

I have R1 concepts from Amazon, perfect for the car and stopping power.

I havent had an issue with them in 2 years.

Almost never, this is a picture of my front driver brake pads after 80,000mi. They are above 90% 2017 Bolt.

I used the R1 concepts drilled and slotted kit with pads. Front and rear total was like 500 bucks. Did it myself. They work great.

Put 306k miles in 13 years, on my brand new '07 Silverado 1/2 Ton before I sold it to a mechanic at my preferred shop (leak in the fuel system/tank that was going to require removing the bed etc).\n\nPrior to that issue, I never had a single thing go wrong with it. Tires, brake pads (original set lasted 200k miles), oil/tranny fluid changes, air filters, wiper blades, were all it ever needed.

They seem good so far. I'm not very handy and I was able to put them on pretty easily.

My Equinox has 10,400km and will always make noise under braking at the beginning of the ride and then gradually stops. Braking feels good though.

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

just waring yall about this company.. they dont care about product quality and safety.. had an issue with my setup only 1 month outta warrty and they said pound sand .. they dont care .. brake pads are made in china and rotors now too.. the pads will fail you big time even if you have a daily driver... never again will i buy a product from them

I originally had r1 concepts rotors and pads but the pads started to squeak like crazy at slow speeds. Rotors were still good so I put on akebono pads and they are perfect.