Brake pads Project Mu or OEM Chevrolet

I have a 13 year old Chevy Volt with 173,000 miles still on its original brakes.

Higher-temp and higher-mu pads (Project Mu HC+R3) + braided brake lines + DOT 4 fluid for me. Slotted fronts, blank rears.

Almost never, this is a picture of my front driver brake pads after 80,000mi. They are above 90% 2017 Bolt.

Put 306k miles in 13 years, on my brand new '07 Silverado 1/2 Ton before I sold it to a mechanic at my preferred shop (leak in the fuel system/tank that was going to require removing the bed etc).\n\nPrior to that issue, I never had a single thing go wrong with it. Tires, brake pads (original set lasted 200k miles), oil/tranny fluid changes, air filters, wiper blades, were all it ever needed.

Red stuff are absolutely NOT track worthy. Will fade in like 1 lap. Any pads advertised as "low dust" tend to fade pretty fast. Yellow might be ok but I think they're still more of a performance street pad. Project MU HC+ are a good streetable track pad, maybe the best, use them on my Megane RS, no trouble with 20 mins sessions on high speed tracks and trackday tyres (Yokohama AD09). A little squeel at low speed on track but quiet enough to live with IMO.

Project MU HC+ pads. These have a higher operating temp range than Ferodo DS2500 and are perfectly streetable too. I get very minor squeal when coming to a stop if it's been a while since they were used hard. they also have great braking feel IMO, nice and sharp, and perfectly controllable. I use them on a Renault Megane RS 280 Cup, I've used them on track with semi-slicks (AD09s) and they held up great in 15 min sessions. Some minor vibration after the day but that fades away with use (or another hard besdding session). Do not recommend Ferodo DS2500 especially with semi slicks. Might be ok for your first day if you're slow, but you'll almost certainly cook them on your second and get deposits on your rotors. Great performance pads or the street though. On my car I only use them on the front, rears are stock.

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

I found Project Mu Club Racers to be decently streetable for a track pad. They do squeal a bit at less than 25 but are tolerable as long as they’re bedded in and you’re giving a decent amount of threshold pressure.

My 2025 RS AWD has been having squealing brakes since 1,000 miles at low speed. It has 3,500 on it now and it's annoying.

My breaks were squeaking with less than 5000 miles. Bad and embarrassing squeaking.