Brake pads OEM Volvo or OEM Mazda

OEM Volvo Brake pads

Had my pads changed (Volvo service centre) at 30k ish miles, at the main dealer and the discs were fine.

Pros: discs were fine
Vehicle: Volvo V90
Mileage: 48280 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads

I inherited a 2011 cx7 from my parents who purchased this car new. They have always kept care of their vehicles. This is a non turbo model. Other than normal maintenance items they had replaced the AC compressor. Since I took it over in 2020, I replaced drive side front wheel bearing and passenger front caliper, brake pads all the way around plus normal maintenance items. 320,000km runs perfectly.

Pros: reliable, runs perfectly
Vehicle: Mazda
Mileage: 320000 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads
LegionVR6
  • Braking:
Rating 4.0

2016.5 CX-5 with 89,000 miles. So far I've had to replace the belt tensioner, accessories belt, water pump belt and breaks (technically I only needed pads and front rotors but I chose to just do them all in one shot since it made a negligible price difference since I was already doing the back pads.

Pros: cheap replacements
Vehicle: Mazda
Mileage: 89000 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads

i remember hearing a guy complain about his cx5 eating through brakes, but the cx5 is the same car as my mazda3, and my mazda3 has seen 70,000km for its rear brake pad/ 90,000km for the fronts, and I drive a mix of city/highway.

Pros: 70,000km rear brake pad
Cons: cx5 eating through brakes
Vehicle: Mazda 3
Mileage: 70000 km
Comment
Is this review helpful?
source
OEM Volvo Brake pads

My only problem with it is the turning radius. The brakes aren't what they should be IMO for triple digit speeds but it is rare I drove at such speed being located in the USA.

Pros: reasonable maintenance costs
Cons: poor turning radius
Vehicle: Volvo S60
Comment
Is this review helpful?
source
OEM Mazda Brake pads

My cx9 was at 3mm on the rears at 52k. Get a caliper compression kit and it yourself. It's not very hard. I did my rears a month back in my driveway for $130.

Pros: easy DIY repair
Cons: rear pads worn at 52k
Vehicle: Mazda
Mileage: 52000 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads

Mazda brakes are notoriously shit. They’re garbage. Buy a set of PowerStop brakes and be done with it. They’re far superior to the Mazda brakes. Go on any forum and you’ll see countless people having the same issue as you. New brakes between 15-20,000 miles. Me included. I’ve owned 2 6s from new. Both needed brakes around 20,000 miles. Both times I put on PowerStops and never had another issue.

Pros: PowerStop superior, no more issues
Cons: Mazda brakes garbage
Vehicle: Mazda 6
Mileage: 20000 km
Comment
Is this review helpful?
source
OEM Mazda Brake pads
theteg
  • Braking:
  • Dust:
Rating 2.0

easy 40 minute job to replace brakes on my 14 Mazda 3 took about two hours. It all pops off super easy going great. Go to put them on, well shit they don't fit. Try the other side for some reason thinking I'm just having a stupid moment. Doesn't work either.

Pros: easy to remove
Cons: brakes don't fit
Vehicle: Mazda 3
Comment
Is this review helpful?
source
1 2 3 4 5 6 7 8 9

Write your review

Help others - share your experience with this part.

Other comparisons
Loading...