Brake pads OEM Hyundai or Hawk Performance

Front - OEM rotors, check Lexus parts too, same same, with Hawk Heavy Duty pads. Rear - Centric or OEM rotors and oem pads. Fluid - Pentosin DOT 4 Low Viscosity brake fluid. Full fluid change every brake job.

Zimmerman blanks and Hawk HPS pads, Motul 5.1 fluid. Initial bite is as good as if not better than stock, but they seem to get much stronger with some heat in them. Biggest plus is the massive decrease in brake dust.

Hawk hps 5.0 and blank Zimmerman rotors

Whole setup feels really damn good.

They're quite a good combo. I glazed them doing too much drifting in the snow, but fixed with a bench grinder and they're as good as day 1.

Hawk Blues are the best I’ve driven on a street driven 930 being used on the track. Thousands of laps with different compounds. Or HPS+ if you’re not that aggressive.

I use Hawk Blues on-track and street pads off. Pads are so easy to change on our cars that it is only a 30 minute job to swap before each track day once you have some practice. The Blues are very abrasive and will clean any bedding material off the rotor if you just lightly ride the brakes for a few minutes while the pads are cold. The Blues have plenty of stopping power when cold on the street, but squeal a lot and eat through rotors very quickly. On-track they have been fade-free for me with excellent modulation using ATE TYP200 brake fluid.

I really liked the Hawk HPS 5.0s on my WRX. Good enough for the track and plenty comfortable for the street

I was leaning toward trying Hawk HPS pad for the GSW, but I first put them on my Focus ST and while I'm satisfied with the performance, I'm disappointed in the noise level; I have a squeak that I cannot eliminate, even after taking them off, re-bedding, and meticulously applying brake grease in the right spots.

That's normal for those. I have been through 3 or 4 sets now and to be honest, I think I'm done. After COVID they just seem to be very unpredictable. I've my last set did some weird stuff sometimes and my current set feels like it needs way more temp then it should. When I did a track day and put dtc60s on it, they gripped immediately on a cold stop where the HP+ felt like it needed some use. None of the other pairs have felt that way. The noise is also totally random now, the first couple sets would be loud unless they had heat, but the new ones are a lot quieter and sometimes loud.