Brake pads OEM Hyundai or Hawk Performance

I went with Hawk 5.0 pads and Zimmerman rotors on my 340i. Very happy with them.

I use Hawk 5.0 pads with R1 Concepts Drilled and Slotted rotors, stops on a dime and cuts alot of speed when adjusting going into corners very predictable

I run hawk 5.0 pads (i used to use ebc yellow but theres been reports of ebc pads delaminating so i stopped using ebc)

I use the centric premium coated blanks & change rotors every time I change pads.

For fluid I use ate200

I swapped out the hoses for braided ss hoses.

I currently use Hawk DTC60’s on my Scion FRS with Motul RBF600 fluid for track days. The brakes feel great to me, I like the bite, and they don’t fade even on multi day events.

Just switched to dba t2 w Hawk ceramics (combo set from new provisions racing) w factory calipers and lines.

I’d been considering brembo swap, but money had to be reallocated, so I abandoned full upgrade dreams. Old rotors were warped and pads were a dusty mess, so pretty much anything was an improvement.

Hawks are quiet, super-smooth/consistent engagement when I step on pedal, and minimal dust. Definitely happy w decision.

For me as an owner of a 2019 Hyundai Veloster with 60k and after 5 years of ownership , the only thing I had to do was change the oil , filter and brake pads.

I got my rotors turned and threw some hawks in it. HPS I think. No issues and they have good bite.

I haven’t heard of fake brake pads but be careful. The main reason I’m commenting is HP+ pads might be good for autox but if you have experience on track, I’d avoid. Granted, my experience using them was on a 2015 WRX but you can overheat the pads pretty quickly on a heavy braking circuit.

They feel amazing and the braking power is noticeably increased but they create an incredible amount of corrosive dust and make a really terrible high pitched noise on occasion under light braking.

I ran Hawk DTC60's for one event. They dust like crazy which isn't the end of the world by itself, but if the dust touches any moisture at all (like the rainy track day) it mixes into what I can only describe as ferrous concrete. So not only is the dust-crete impossible to remove by any normal means, it then rusts like crazy, turning whatever wheels you have into a runny orange mess. I tried multiple different wheel cleaners, multiple brushes, soaking, anything and nothing could get it off. I had to use scotch brite and scuff the hell out of the wheels to get it off. Fortunately I run cheap TRM wheels and it's a track-only car otherwise I would have been livid.