Brake pads Hawk Performance or OEM Mercedes

Front - OEM rotors, check Lexus parts too, same same, with Hawk Heavy Duty pads. Rear - Centric or OEM rotors and oem pads. Fluid - Pentosin DOT 4 Low Viscosity brake fluid. Full fluid change every brake job.

Zimmerman blanks and Hawk HPS pads, Motul 5.1 fluid. Initial bite is as good as if not better than stock, but they seem to get much stronger with some heat in them. Biggest plus is the massive decrease in brake dust.

Hawk hps 5.0 and blank Zimmerman rotors

Whole setup feels really damn good.

They're quite a good combo. I glazed them doing too much drifting in the snow, but fixed with a bench grinder and they're as good as day 1.

Hawk Blues are the best I’ve driven on a street driven 930 being used on the track. Thousands of laps with different compounds. Or HPS+ if you’re not that aggressive.

I use Hawk Blues on-track and street pads off. Pads are so easy to change on our cars that it is only a 30 minute job to swap before each track day once you have some practice. The Blues are very abrasive and will clean any bedding material off the rotor if you just lightly ride the brakes for a few minutes while the pads are cold. The Blues have plenty of stopping power when cold on the street, but squeal a lot and eat through rotors very quickly. On-track they have been fade-free for me with excellent modulation using ATE TYP200 brake fluid.

I’ve got StopTech st-40’s and run Hawk HP+ pads. They have good bite and hold up pretty well, they’re just SUPER loud until they’re hot and are also fairly dusty

I was leaning toward trying Hawk HPS pad for the GSW, but I first put them on my Focus ST and while I'm satisfied with the performance, I'm disappointed in the noise level; I have a squeak that I cannot eliminate, even after taking them off, re-bedding, and meticulously applying brake grease in the right spots.

I ran Hawk DTC60's for one event. They dust like crazy which isn't the end of the world by itself, but if the dust touches any moisture at all (like the rainy track day) it mixes into what I can only describe as ferrous concrete. So not only is the dust-crete impossible to remove by any normal means, it then rusts like crazy, turning whatever wheels you have into a runny orange mess. I tried multiple different wheel cleaners, multiple brushes, soaking, anything and nothing could get it off. I had to use scotch brite and scuff the hell out of the wheels to get it off. Fortunately I run cheap TRM wheels and it's a track-only car otherwise I would have been livid.