Brake pads Ferodo or OEM Chevrolet

I have a 13 year old Chevy Volt with 173,000 miles still on its original brakes.

if you want raw stopping power then Ferodo DS2500's are great.

I was a huge fan of Ferodo DS2500s on Centric rotors. They performed insanely well for street duty and were decent enough for track days.

Ferodo DS2500 is about the best pad you can get.

I've got OE spec ferodo on my 208 GTi no complaints from me, got brembo on my Saab 9-5 aero again all good I would avoid the cheaper end of the market

Ferodo DS2500 were good in my daily/tracked GTI and track NB Miata, until I got GLOC track pads on the latter. Which are awesome. BUT the DS2500 held up to the track really well, I'd definitely say for a daily that gets tracked they're about as good as you might get. Grease the contact points on the pad with copper or other compatible grease and i think they don't make much noise at all.

I'm running Ferodo DS 1.11. and they're fine on the streets even during winters when it gets even as cold as -25C

I switched to the Ferodo DSUno. I am satisfied with its performance, but they seem to struggle because of something. Today, after the track day on Saturday, I checked it and found a crack and a gnawed edge. Also, they have uneven wear, about 0.5-1mm difference. The differences are between the top and bottom parts of the pads, front and back parts and on different sides of the same rotor (inner and outer pads). Uneven wear was with the old pads as well. Recently, I installed brake air ducts, and after going out from the track, the temperature was, in the worst case, 480C degree, which looks fine for these pads. In total, I drove for about 3 hours on tracks, one on a wet track (so no hard braking) and two moderately/hard(8-9/10) braking. The brake rotors are also new, Zimmermann blank, installed with pads. The initial thickness of the pads is 16.4mm (with the plate, the plate is 5.5mm, so the "pure" pad is about 11mm) Currently, I have eaten about 4.5-5mm of the pads in 3 hours of tracking.

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

My 2025 RS AWD has been having squealing brakes since 1,000 miles at low speed. It has 3,500 on it now and it's annoying.