Brake pads Ferodo or DIXCEL

If you have 312 mm front rotors I'd suggest to upgrade to FER-FCP4433G

DS3.12 pads https://www.brakes-shop.com/fer-fcp4433g-ferodo-ds3-12-brake-pads-front.html and Motul 600 / 660 brake fluid (or Castrol React SRF).

With this setup you will be limited by your tyres and suspension.

Don't buy DBA rotors and pads or EBC pads. You will destroy them (like crack in pieces).

Don't run with OEM fluid or pads \u2014 you will definitely lose stopping power relatively early on.

Back in May I swapped OEM pads for Ferodo DS2500 for my first track day in my GR86. Otherwise the car is bone stock. I noticed some slight pulsing of the steering wheel but only during hard braking (100 to 30mph). No brake fade that I noticed.

DS2500’s were the best hybrid pads I’ve used. But I only did 1-2 a year.

Gt4 brake pads ran me about 1000-1100 for ferodo ds3.12.

Ferrodo DS2500 is probably the best dual duty pad.

Dixcel M-Type are the least dusty street pad I've ever used. A little pricey and straight from Japan, but they aren't kidding when they advertise "ultra low dust". Have about 1500 miles on them so far and they're great on the street and for the occasional togue/mountain days.

Dump the OEM pads. I went Dixcel in my M3 and the thing stops better and there’s so much less dust. Traded off is squeal at higher brake temps.

The 3.12s have a LOT of bite and can make modulation tough on certain cars. On my E46 M3, I run DS UNO or DS1.11s. That's with the AP race kit front & rear. Didn't like the 3.12s for that application.

Ferodo DS2500 feel good but don't last as long as the CP's and have a bit more dust.

I used ferodo's once... Lasted me 2months daily and a single trackday. I'm only in a Z4.