Brake pads ENDLESS or OEM Toyota

ENDLESS Brake pads
SolipsistSmokehound
  • Braking:
  • Noise:
Rating 4.5

I’ve been told by some very experienced S2000 drivers that this is the best braking setup outside of a BBK. It’s streetable as well, if you don’t mind a bit squeaking. Make sure to burnish/bed the pads in beforehand for better performance.

Pros: best braking setup, streetable
Cons: a bit squeaking
Vehicle: Honda S2000
Comment
Is this review helpful?
source
OEM Toyota Brake pads

I had this symptom as well 2 months ago because my brake pads were worn out. The rotors was fine so only had to replace the brake pad and the braking vibrations went as well.

Pros: braking vibrations went
Cons: brake pads worn out
Vehicle: Toyota
Comment
Is this review helpful?
source
OEM Toyota Brake pads

DIYer advice: buy Toyota pads/rotors from your local dealership's parts counter. Take a photo of your VIN for the parts guy. Once you're in their system, buying parts will be easy. You'll typically pay 20%-25% more for OEM parts, but do you really want to buy cheap pads/rotors?

Vehicle: Toyota
Comment
Is this review helpful?
source
ENDLESS Brake pads
PlatinumElement
  • Braking:
  • Noise:
  • Dust:
Rating 5.0

I’ve tried a lot of pads on my ‘18 tS, and by far the best have been Endless SSY. They’re great on the track, grip great, but are also silent and almost dust-free.

Pros: grip great, silent
Cons: difficult to find, pricey
Comment
Is this review helpful?
source
OEM Toyota Brake pads

My oem brake pads, (‘23 A-91MT) are getting low ish after a year of driving her and going to the track. OEM ones seem expensive but they did last a hpde 1/2 driver a year.

Pros: long lasting, good for track use
Cons: expensive
Comment
Is this review helpful?
source
OEM Toyota Brake pads
omvargas
  • Braking:
Rating 2.0

This happened to my Gen2. I gave it to some guy to change pads and these lights came out after. I think he didn't do it properly and air entered into the line. I then took it to a local Toyota dealership where they fixed it. (I don't recall what they did exactly, maybe flush and replaced the break fluid). I was fearing it was the actuator, which as other have posted, is very expensive on this Prius. I had to drive very slow and careful, because I had no power in the brakes, so they were hard and slow. No ABS. No regen either.

Pros: fixed by dealership
Cons: no brake power, hard brakes
Comment
Is this review helpful?
source
1 ... 2 3 4 5 6 7 8 9 10

Write your review

Help others - share your experience with this part.

Other comparisons
Loading...