Brake pads EBC or Tesla

EBC Red Stuff pads will fix ya up nicely. Way less dust, better performing.

I use EBC blue stuff on my Mach 1 for national competition in F Street. Coefficient of friction of .52. modulate well, try them on the street all the time, and take a pretty good beating.

Also swap out pads, I like ebc redstuff, about 20% of the dust as stock. isweeps have even less dust but don't have the bite that stock or ebcs do.

I put on EBC redstuff and they work well.

But the EBC SR11 and SR21 pads have been a game changer for us with regard to wear rate. We run these on our endurance race car and so far they have blown everything else we have tried out of the water. We just started using these so my experience is limited. But we just ran an 8 hour enduro at the ridge and used 1.5mm of front brake pad. This length of enduro at this track would usually consume an entire set of front pads down to damn near the backing plates. This is on a fox body mustang that’s 2600lbs and makes 330whp.

EBC blue on stock rotors, and stock suspension for 2 seasons so far... The pads are done, but I think I'll be getting the EBC blue again

I haven't had any issue with yellow stuff on my 350Z doing hot track days in Miami. But the brakes don't last as long as they should. So I'm trying blue next time and I might go to the full track pads whenever that isn't enough.

Raybestos rotors and ebc redstuff pads, a bit aggressive but you get used to em

Many years ago, I converted my 88 Cabriolet to Corrado G60 front brakes. The pads were junk. They ruined [caused the front rotors to warp] a couple sets of rotors before I pitched the pads.

I also have some EBC braided lines and yellow stuff on my ST. But I think I didn't really brake them in before using them very hard. Needed to brake from around 200kph for a corner on the Nurburgring and fried them. The bite it used to have is gone now, I think I overcooked them