I did Project MU B force pads. DBA 4000 rotors, Stop tech stainless steel brake lines, Motul 660 brake fluid, radium brake booster brace(a must). Make sure to set those pads in the correct sequence and they gonna rip your face off bud! I had 6 piston brembos also, what a difference!
I run yellows and they are brilliant. The stopping distance is about 50% more. Been doing a fair bit of miles and they dont seem to be wearing out excessively. I wouldnt go for anything more aggressive for daily use though you need cold stopping power for when somone pull into your lane during long motorway trips in the rain.
My oem S6 6 piston brembos with EBC redstuff pads are great
I just did brakes on my '13 S4, went with EBC OE Rotors and their Red Stuff pads. The red stuff is definitely low dust compared to the crap stock pads. Very grippy on initial bite and totally silent no squealing.
Switched to EBC red fronts. A bit surprised over the dust level comparing it to previous MK7 GTIs and GLIs I had them on. Seems close to OEM pad dust on the MK8s
I do not recommend these for the street, however the track performance is off the charts.
They’re track/race pads, but I rarely track my car. It’s not a daily, just a fun weekend car, but I find the pad performance to be amazing and they’re not noisy like everyone says they would be.
I have EBC Greens on my '95 miata with 80k miles and 3mm on each corner due to spirited driving.
I upgraded to the yellows from stock pads and they held up fine but they were getting hot and I could smell them in my first session.
the brakes on the VB are pretty bad with zero bite in the first few inches of brake travel. I’ve had the past 2 generations on WRXs for OEM brake comparison. Ordered a full set of EBC Ulitmax2 OEM replacement pads to help a bit.
Write your review
Help others - share your experience with this part.
