Brake pads EBC or Bosch

I did EBC red stuff and replaced pads all around at ~50k miles. My rotors weren't bad at all so I kept the old ones on. My pads coulda gone a few more years also. No complaints!

Rear Calipers -Bosch Pads

Slotted are ok drilled are not going to hold up to daily driving. I tried stopteh , ebc and brembo all cracked at the drill points prematurely. I have a 2009 crew cab sport and use it to tow a Dodge Viper. EBC slotted and greens are what I use and have gotten the best mileage out of that pairing. The original mopar brakes lasted the longest but the greens decrease braking distance when towing IMO.

I run yellows and they are brilliant. The stopping distance is about 50% more. Been doing a fair bit of miles and they dont seem to be wearing out excessively. I wouldnt go for anything more aggressive for daily use though you need cold stopping power for when somone pull into your lane during long motorway trips in the rain.

My oem S6 6 piston brembos with EBC redstuff pads are great

I just did brakes on my '13 S4, went with EBC OE Rotors and their Red Stuff pads. The red stuff is definitely low dust compared to the crap stock pads. Very grippy on initial bite and totally silent no squealing.

After a year I replaced the brakes and rotors, and the mechanics specifically said to stick with major brands like Bosch because they are standard, easy to work on, and easy to order parts for.

Switched to EBC red fronts. A bit surprised over the dust level comparing it to previous MK7 GTIs and GLIs I had them on. Seems close to OEM pad dust on the MK8s

Have EBC redstuffs on rear wheels of my XF 25t. Good breaking, silent, but now at half pad started to make a lot of dust (much more then genuine factory fitted Jag pads still at the front) so I will change them when the time comes and go back to Jag pads.

For my (owned 3 years, purchased used) 2014 Honda Crosstour I've always had to grind down the edges of the pad mounting plate tabs on Bosch brakes a couple of mm to get it to fit into the calipers. I have just received a new set, and while I still had to grind down the edges to get them to slide into the calipers, the top and bottom edges were MUCH shorter than the previous pads. So much so that when braking after reversing direction, the pads will shift in the calipers with a noticeable 'click' as the brake pads engage the disks to slow the car and are thus moved to the other end of the caliper. The overlap between the brake pad plate and the 'C' in the caliper where the tab meets the caliper is only 2mm or so. Definitely less than I am comfortable with.