Brake pads Carbotech or OEM Nissan

I run carbotechs on my GT350. Multiple weekends on them.

Been running carbotechs on my m2comp and C's and 2 seasons. Love them. Xp10 up front, xp8 for the rear. Track only pads that I can drive to the track with

I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.

I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps

XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this

I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.

carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.

Brake inspection during the tire rotation, replace as needed (haven't needed to yet thanks to regenerative braking - I'm at 62k and I think I have OEM brakes).

I use carbotech xp8s. Dtc 60 or 70s would also be a good choice. Be warned through track pads driven on the street will accelerate rotor wear. I hated the Ferodo ds2500s when cold.

I have a Nissan Pathfinder 2022 and have had to replace brakes twice in 2 years.