Brake pads Carbotech or OEM Chevrolet

I use Carbotech xp10 in the front, xp8 in the rears. Love them. Semi heavy car but they feel great the entire weekend. They are very loud on street though

I went from EBC to Carbotech. It’s a night and day difference. I’m running XP8, but my car is very light.

I've been to 20 track events to this day I'm still running OEM calipers. Just carbotech pads. You don't need a big brake kit at all. The oem cracks because of improper cooldown. I learned that after a session to take my cooldown lap seriously and ever since then i stopped cracking AutoZone rotors

I ran stock rotors for a long time with carbotech xp10/8, front brake ducts, stainless lines, and Motul 660. The XP10/8 + ducts was sufficient for 20min session the tracks I drive.

I'm using carbotech xp8 on my 3800 pound sedan. They've survived 6 days at the track plus occasional driving around town for a year.

Almost never, this is a picture of my front driver brake pads after 80,000mi. They are above 90% 2017 Bolt.

Hey, I track. MK7.5! The floating calipers flex which means you get more pressure on the outer half of the rotor. It's annoying but it's not a problem in my experience.

Something like a Carbotech XP12 pad might do better with the heat but adding brake ducts from the RS3 is cheap and will help quite a bit.

Girodisc should have a 357mm disc available when you've gone through the OE rotors. They're slotted instead of drilled and are 2 piece (aluminum hat).

I am currently using Carbotech XP10's in front and the XP8's for the rears. I really like them and have not had an issue so far. Plus the company has great customer service. They are definitely NOT a street pad, and I need to swap them the night before a track meet and put street pads on the day after, but the effort is worth it.

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

My breaks were squeaking with less than 5000 miles. Bad and embarrassing squeaking.