Brake pads Carbotech or Hawk Performance

I went with hps 5.0s and they’re great but I should’ve gone less aggressive

I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.

I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps

XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this

I run Hawk HPS 5.0 on the street and just pad slap DTC-60 / 30 front / rear and it works fine.

I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.

The racing shop that does the work on my track car picked out Hawk HPS 5.0 pads for me for this same purpose. They worked great on the track and don't have much more noise than a factory pad.

I'm only in HPDE2, though, so my track evaluation may not mean much. They were definitely an improvement over the stock pads I used in the previous track outing.

Hawk HPS 5.0 front and rear.

They dust the same as what came on my car from the factory, the first 1k miles they felt like they needed some extra heat in them to get a "normal" feel but by the time I left my neighborhood it was fine. Either I'm used to it now or it went away.

I ran HP+ pads and nearly ruined some STI Rays wheels I ordered from Japan. The key to cleaning the dust off is using a cleaner that has an iron remover. Sonax makes a good one. Meguiar's all wheel cleaner also works OK. I had to treat each wheel about 5x with a soft bristle brush and still ended up using a blue Scotch Brite to get the hard deposits of dust. I ended up removing some paint in some indescreet locations. I was super bummed. I no longer run these pads and run ceramics for the street. I plan to run more aggressive pads when needed, but haven't picked anything yet. The HP+ are great. The modulation is amazing. The bite, even when cold, is awesome. But there's a major trade off.

I changed out the oem and ran Hawks for a while, braking distance wan't much difference but the brake dust was terrible, Rims where dirty all of the time.