Brake pads Brembo or OEM Chevrolet

My Polestar 2 has 3 levels of OPD which is awesome. My brakes are still fairly new and I have 34800 miles on it as of today. I very rarely use the friction brakes unless I take it to the track and thats when the Brembos brakes all around really work.

Brembos I put on have been amazing so far

I've got the rs5 with ceramic front brakes, I'm looking to get the pads replaced, back ones are 100 for a genuine set, but front ones are nearly 1000 for a genuine set?! I inspect my front pads and see they are made by brembo and have audi branding on it. A little bit a research and I find OE equivalent pads from brembo for only 240. They felt the exact same to me on the track.

brembo. better than the bmw ones

Brembo brakes, they look awesome and feel so much better than the wimpy brakes my BRZ had.

I got GT PP brembo brakes from shelby for ~500 dollars, including shipping. New front pads and rotors on them too.

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

The oem brakes on my 2012 were lackluster and kept seizing pins or calipers so I fixed the problem for good

My brakes are overheating when I break the car from around 190kph (118mph) to around 30kph (19mph), I smell the brakes burning and see a lot of brake dust on the wheel. Even the brakes feel a bit spongy for a while after, but it firms back up.

Ein Problem bei den Brembo Belägen die ich hatte war aber immer dass die nach ein paar tausend km quietschen wie Sau. Ließ sich auch nicht nachhaltig beheben.