Brake pads Bosch or OEM Subaru

I'm running bosch quietcast ones on mine. They were on rock auto for like $70 shipped for both front and rear. They are ceramic

Decided to pull the wheel, and found a TRW stamp on the caliper, so it's been ID'd. Anyone need a set of Bosch BC1456 pads for the Bosch calipers?

There’s a rotor and pad combo I’ve used on our allroad 6MT, Escalade ESV & 07 Beetle Vert 3x White. Through trial & error we discovered the only way to keep the under braked 3T Escalade rotors from warping due to pad material buildup was to go countersunk gas slotted & x drilled rotors. They were added to the other vehicles because we found Bosch ceramic pads and the hot galvanized rotors will NOT rust. The Beetle has been running the same pads and rotors since ‘14. They’re silent, don’t leave dust and have amazing pedal feel when cold or hot. They also look new because they don’t rust. The last and unexpected benefit of these rotors is that they don’t fade from heat or water saturation.

Usually for pads though I go with Bosch ceramic for my cars and Bosch semi metallic for my trucks. I have never had an issues and get great life from my pads.

I've been very happy with Bosch Quietcast. I use them on all my cars. Pricier than Centrics, but never had a problem in 20 years and a dozen cars.

When I bought my 17 PP the previous owner had Bosch pads installed that screeched nonstop, i avoided driving through parking lots because of how bad it sounded. I replaced them with Brembo pads and couldn’t be happier

I just put Bosch QuietCast pads and rotors on my Volvo and they’re great.

On my recent rear brake job on the Mazda5 I ordered Bosch pads through Amazon. They seem to be doing the job and I have no complaints.

I had an 2017 Outback 2.5, had it since April of 2017 until last week, during that time I put on 93k km on it. I wish I had gotten the 3.6, I got the 2.5 hoping to save fuel, my average was around 25mpg for lifetime, and I drive a lot on hwy and country road, I never once was able to hit the 30mpg even if it's just me in the car and driving 50mph on the country road, this part I really feel like Subaru should correct their mpg reading, in winter it can get as bad as 18mpg in the freezing weather, as when it's cold the transmission will make the engine constantly rev at higher to warm it up, the 2.5 is also not a smooth engine when at idle, I had a vibration issue that was deemed normal. Overall, it's a reliable car, but its not a durable car, another thing is, when taking off quickly from a stop, it can really bog down, most people are used to first gear and just boot, but these CVT don't have first gear and it can be rather unexpected, I've almost got hit from behind a couple times from that. The eyesight is a good feature, the lane departure can be annoying at times but I was ok with it, these cars have an issue with windshield chipping, and if the car has eyesight, the windshield need to be a specific one and then the eyesight needs to be re-calibrated, this happened to me TWICE, and it got expensive very quick. OEM tires are lousy, by lousy I mean it doesn't even get good mpg, doesn't get good grip in ANY condition and puncture easily if you take it to any sort of gravel road, I had puncture the tire within 1200km, I just got some decent A/T tires after, no problem for the last 90k. The brakes are soft, so first thing I did was changed the pads.

I just replaced the pads (Bosch BE1633H) and rotors (Textar 5Q0615301G) on my MK7 R, and after torqueing everything I noticed a clunk when rolling up and down my driveway (happened only when going from forward to reverse or vice versa). I jacked the car up, took the wheels off, and checked all the bolts, everything was tight and torqued to spec. I then noticed that the brake pad itself is shifting.