Brake pads ATE or OEM Chevrolet

ATE und Schluss aus. Damit hatte ich immer top Qualität und nie Probleme.

I just put some ATE pads on the rear. High quality for only $30.

When you need brake pads and rotors get ATE.

I used ATE ceramic pads on my mk7 pp and so far they are great. Barely any dust, no noticeable wear on the rotors after 3k miles, and no extra pedal pressure required.

Almost never, this is a picture of my front driver brake pads after 80,000mi. They are above 90% 2017 Bolt.

stick with ATE or akebono. both good for their price. have ran both on my e39 and they work great with their respective rotors

Brakes feel fine when driving, but after they cool and I go out again, the pedal feels spongey. A few hard stabs and it returns to normal, until I come in and let it cool. No fade while driving, and pads survived despite having been on the car for over 2 years of road use, although they need replacing now really.

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

Back in September 2024, I bought two Chevy Equinox EV 2025s — one for me and one for my wife. Both vehicles have less than 10,000 miles on them. And guess what? Both are already having the exact same issue: the brakes make a horrible squealing noise every time you press the pedal, and when you go in reverse the sound is absolutely unbearable.

I’ve taken both SUVs to the dealer twice already. Each time I had to pay $35 for a brake inspection, and both times they told me “everything was fine.” Now, on the third visit, they suddenly tell me the brake pads need to be replaced, and it’s going to cost $498 PER VEHICLE. That’s nearly $1,000 out of my pocket for what I strongly believe is a manufacturing defect.

Here’s what frustrates me the most:

• Both vehicles are covered under the extended warranty, but the dealer says brakes are “not included.”

• They claim the warranty only covers the battery and motors.

• How is it possible that two brand-new vehicles, same model, same mileage, bought at the same time, have the same brake problem, and it’s NOT considered a factory defect?

This makes zero sense. Honestly, I feel scammed. I trusted Chevy, bought two brand-new EVs, and in less than a year they’re already trying to squeeze almost a grand out of me for something that should not be happening.

Hatte mal teure ATE Bremsen die sofort verrostet sind. Nie wieder.