Brake discs Zimmermann or OEM Toyota

Zimmerman plain discs are great.

Got Zimmerman’s on my 328 sport. I think I’m going on 50,000 miles on them and they’re still performing well and aren’t rusty. Zimmerman‘s rep is as one of the best aftermarket rotors

I have Zimmerman rotors and akebono ceramic pads on a 2018 base. They are great. 90% less dust on rims.

I always use Zimmerman coated rotors and Hawk HPS pads on my street Audis. Pads tend to last about 100,000 miles.

I have 65K on my Zimmermann rotors and Brembo pads. Fronts are 6mm, rear are 7mm. I’m expecting at least 30K more before I change anything.

I got Zimmerman blanks and Hawk HPS pads because I've used them on my Camaro before and was quite pleased with them. They are a great street pad.Massive reduction in brake dust, braking performance feels similar if not better than stock UNTIL they get some heat in them. Once they get hot, there is a huge increase in stopping power. This is not like a racing pad where it's shit until it gets hot, it goes from good to fantastic.However, high temp fluid is an absolute MUST.

Zimmerman rotors and OEM pads. Less brake dust, and no squeaking

Zimmerman rotors are top notch.

A few thousand miles later and I started to noticed a some shaking in the steering wheel when braking in the higher speeds (60-80mph). I called a few shops in my area that were highly recommend on both here Reddit, yelp, and the forums. Most pointed to warped rotors. One shop says to have the rotors machined and another says to have the completely replaced. What are your guy’s thoughts on having them machined?

I keep hearing my brakes squeal when I drive and it's really bothering, so I'm trying to figure out what could be causing it or if it's something I have to deal with. I bought a Zimmermann kit with Textar semi metallic pads. My buddy thinks I should've removed the Coat Z anticorrosive off the rotors before installing but it says on their website it's made to be installed with it on. The only thing I can think of is maybe I didn't lube the moving surfaces enough or I need to do a better job bedding them in.