Brake discs OEM Toyota or MEYLE

I did the tundra upgrade 10 years ago, and I'm STILL on the same rotors!!!

I replaced mine around 55k miles. You’ll be so much happier starting fresh, no shuddering, better braking power.

I’ve bought at least 6 cars for family/friends using Cinch and have found them to go above any other standard I’ve come across in 40 yrs in the motor trade. A few yrs back bought my mum a 3 yr old Aygo with 9,000 miles on the clock and it was delivered with new front discs and pads fitted. I queried this with the delivery driver as I wouldn’t have expected them to need replacing at such low mileage. His reply was “yeh, If there’s Any sign of rust on any brake disc then we’ve been told to replace whatever is needed”

I usually just use the built in threaded rotor removal bolt holes on Toyota rotors, they usually work very well... Much better than beating the shit out of the rotor with a sledge hammer, all that does is hammer the wheel bearings to death unnecessarily.

I will say this that I have noticed a measured difference in my vehicle's ability to stop and in the Brake bite is more pronounced

I upgraded slightly by going with GLI brakes front and rear. Did basic Meyle rotors with Akebono ceramic pads. Couldn't be happier.

Just an FYI. I just did the brakes and rotors on my LS430. Brake pads are the easiest job ever did. it's just a pin and a clip. Rotors require removing 4 bolts and replacing them as they are drop bolts. Still easiest brake job I have done on a car and I did for around I think 400 with OEM parts

About a year ago, I installed a complete Meyle control arm kit in my B7 A4 Avant . At the same time I installed a set of Meyle geomet coated rotors and Akebono ceramic pads on all 4 corners. The car still rides, handles and stops like new. The rotors still look new with no warping and no rust after a tough New England winter.

Many heavy 4WD vehicles out there chew through rotors in 25k miles. My LandCruiser goes through them every 20k. And yes, I have checked the thickness and I've tried resurfacing old rotors a couple times but it always resulted in short life and problems.

I bought my Meyle rotors and installed them end of September last year, about 10-11 months ago. They are completely worn out already and need to be replaced.