Brake discs GiroDisc or OEM Toyota

Just pads and rotors is fine. Probably cheap rotors causing the issue. Go OEM Toyota. Almost positive Akebono pads are oem, as well as Advics rotors. Either way these will not warp.

My experience with hundreds of thousands of miles on many different Toyota/Lexus SUV’s is to go with OEM. You shouldn’t have to do anything with the calipers unless one is frozen. You’ll know that for sure when you try to collapse them to put in the new brake pads. Otherwise just new rotors, pads and all hardware (pins, shims, etc)

I did the tundra upgrade 10 years ago, and I'm STILL on the same rotors!!!

I replaced mine around 55k miles. You’ll be so much happier starting fresh, no shuddering, better braking power.

I’ve bought at least 6 cars for family/friends using Cinch and have found them to go above any other standard I’ve come across in 40 yrs in the motor trade. A few yrs back bought my mum a 3 yr old Aygo with 9,000 miles on the clock and it was delivered with new front discs and pads fitted. I queried this with the delivery driver as I wouldn’t have expected them to need replacing at such low mileage. His reply was “yeh, If there’s Any sign of rust on any brake disc then we’ve been told to replace whatever is needed”

Reliability and safety are my main concerns right now, so I also have Girodisc rotors

Almost every car in our PCA club runs GiroDiscs, even the GT and RS cars. Never heard a single complaint, and love them on my C2 and GT3.

I usually just use the built in threaded rotor removal bolt holes on Toyota rotors, they usually work very well... Much better than beating the shit out of the rotor with a sledge hammer, all that does is hammer the wheel bearings to death unnecessarily.

We are on our fifth weekend with our girodisc two piece rotors. Yes they are expensive, but they are worth it. They are so much better with heat management.

Many heavy 4WD vehicles out there chew through rotors in 25k miles. My LandCruiser goes through them every 20k. And yes, I have checked the thickness and I've tried resurfacing old rotors a couple times but it always resulted in short life and problems.