Brake discs Detroit Axle or OEM Volkswagen

Just discussed this last week. I side with my VW dealer on it. They recommend just replacing the rotors, its really not that much more than having them turned, considering you almost guarantee no pulsation, no shimmy or shudder and more even brake wear.

Engine braking is how I got 60k miles out of the original brake rotors and pads on my '07 GTI as well as a steady 30 mpg while barely trying.

Rallye 1.8T you are the man! Thanks for the tip and saving me a lot of time and money. The mk5 312x25mm rotors work on my setup. Only thing I have to do is run one thin washer between the bracket and spindle.

I had the car in at the dealer on Saturday morning. Spent about 3 hours there. The service guy took it and had the front rotors replaced. They agreed there was quite a bit of shake in the steering wheel. All in all, good experience.

If VW won't cover the costs, then don't buy the VW rotors again. Tire Rack sells Centric brand rotors for our vans. These are the same rotors that Powerslot rotors use, just without the slots. They are about $50 each are a much better quality than the stockers. Yeah it's $200, but I would bet these will not warp like the stock rotors.

I'm actually running corrado g60 rotors right now that i redrilled to 5 bolt since my last set warped.

I am happy with the R32 setup so far ( rotors are freaking heavy); but if I was to upgrade it would be either AP or stoptech trophies....

The rear brakes will be an absolute nightmare. There is not a lot of room. As far as I am aware, MK6/MKV R/R32 brakes are the same, so... prepare yourself for a miserable time doing the rear rotors. The rear pads are fine. The rotors suck ass.

Unfortunately the problem is inherent in the design of the rotors. Not in where they were produced. You can put the best rotors in the world on that car and they will still warp. Vw/Chrysler would need to spec a larger and thicker rotor to help dissipate heat properly. All aftermarkets will make the rotor to fit, based on the crappy oem specs. So, get used to having new rotors put on...because recall or not, Chrysler still needs to redesign that rotor. FYI, I'm in the same boat as you guys! These rotors suck!

The cause is Sub-Standard, Cheap "Made in China" Rotors.