Reviews of Nissens engine radiator

Nissens is good, put a long zip tie around the upper plug on the passenger side above the transmission fluid return, the plugs can push out.

I've had my nissens radiator for years and it's fine.

I just installed a nissens. went fine, good fit.

I just looked on rockauto. Buy the Nissens 61033. HD cooling radiator. They are an OEM manufacturer. And it’s only $154. Fraction of the cost of Mopar, and the same quality.

I replaced mine with a Nissens and it’s been working great for over a year. The way the drain plug felt when I installed it was a bit concerning though.

I bought a Nissens radiator because it was the highest rated one for my car. Everything went so smooth initially. Bled the system, pressure tested it, drove it for 20 minutes, and it ran beautifully. Checked for leaks, nothing. Then, the moment I drive off the lot, my low coolant light comes on and coolant was pouring out the bottom of the car. I got a (2E83) *Electric coolant pump, reduced power operation* error. The car never overheated or went into limp mode.

My NISSEN didn't last 2 years before it failed catastrophically on the plastic side tanks.

If you can\u2019t afford the OE Modine radiator, get a Nissens one from FCPEURO with BMW hoses (NOT Rein which are absolute junk). Stay far away from Mahle radiators which are also junk and not worth your time.

Pretty sure oem is mahle but nissens are good for sure

Nissens rads are very good tbh, better than OEM,