Reviews of Exedy parts For Business

If you do end up replacing it. I have found success with the exedy clutch kit and luk flywheel combo.

I run the exedy OEM replacement kit. Whatever you do make sure you replace the bearing guide and use a new OEM bearing. Throw away the one that comes in the kit it's trash and won't last half the life of the disc.

I used exedy organic clutch kit and works great, I'm around 350-380 hp.

My go to is exedy stage 1 organic clutch kit. It can hold like 400 hp before it gives up and it's a good daily driving clutch. Also exedy is the oem for many cars the their oem labeled stuff is the same as \"Honda\" oem

I got it and am loving it. feels great

Thats what I have in my NC, it has been great for my 2.5 swapped car. Clutch feel is very good, a little heavier than stock but not much. Flywheel is very livable too.

I have the Exedy stage one clutch and flywheel combo. My old clutch began slipping (130k miles) and I’m super happy with the lightweight flywheel. It does has transmission chatter which isn’t terrible but noticeable. It is a lot quicker and the clutch grabs hard with a little bit of a stiffer petal. If it’s hard to shift in certain gears think about adjusting the CMC. The Exedy oem clutch is also really good. IMO flywheel is very much worth it if you don’t mind some cabin noise.

I used the OEM Exedy clutch kit on my 2012 STI a few years ago. It's held up reasonably well, although I don't drive like I stole it very often. The only issue I noticed was the clutch felt slightly lighter than the stock one.

I used the Exedy OE clutch kit like many do. It turns out that Exedy only makes the clutch disc and pressure plate. The bearings are sourced from China, and I've found a few people that have had them fail very quickly (sometimes within weeks). I ended up ordering and using SKF bearings for both.

eurospec flywheel exedy stage1 clutch kit (**** spec clutches for life)