Best Brake pads for Mazda 6

Ran a kit of EBC brakes, green stuff i think on my old Mazda 6. Was a pretty decent upgrade over OEM and not much more expensive.

i have ebc pads and rotors worth every penny

Akebono have been better for my 6 than the OEM. OEM pads are not all the same. They may meet the same minimum spec but not all are top tier. For example the rear brake pads on my 6 OEM were great and were made by TRW. the last set of OEM rear pads were from another manufacturer and are dusty and wear fast. My recent front OEM pads are the same. I'm going back to Akebono pads when the weather is better

I recommend Power Stop ceramic pads and solid rotors. The 6 is an economy car by design. So, there are no practical or worthy trade offs to other types of rotors/material besides aesthetics.Since it's a 16', I highly recommend doing a full brake job even if your mileage is low. If I am correct, the 2016 model has an electronic brake that requires a service mode to be able to do the job(refer to manual since I can't help you on that).

I put Wagner on mine. They have been good for around 35k miles on them so far. I don't see me replacing them for another 15k. I didn't like the OEM one and braking is really one of the weakspoints for the Mazda 6.

I installed the power stop ck8067 and I’m happy with them. I went with the geomet coating to help with corrosion around the bolts and wheel hub; the coating gets worn off behind the pads instantly. Only time will tell how much it helps though.

So far I've spent 400€ on brakes, 100€ new battery, 1200€ on axles and other components related to them and maybe 150€ on oil and filters (2 oil changes so far)

4 years ago I had my daughter, before taking my 2008 Mazda 6 back to college with her, install new Brembo "OE"/standard type pad sets front and rear and new Brembo rotors in the front. The front pads and rotors were so thick that the caliper piston cups had to be ENTIRELY retracted into the pistons to fit over them. After completion of the job and the performance of the pad/rotor break-in procedure, the already capable car was turned into a braking performance monster. It was like if you depressed the brake pedal a millimeter the car would start to decelerate markedly! And rapid stops were unbelievable quick and drama free. So I absolutely recommend Brembo products (have installed Brembo pads on 2 SUVs as well) and have always been impressed with the results!!

I installed EBC Red Stuff street/track pads on my 2008 Mazda 6 about 10 or so years ago - front pad set only. I selected the Red Stuff pads because I wanted the performance of a trackable pad set, and I got it! The pads were also advertised to be a "low dust" formulation, which we all desire, of.course. I installed them with ceramic pad grease, and did the brake pad bedding procedure as specified by EBC. Prior to installing and bedding the pads, I had the beginnings of very slight front brake pulsation/lateral rotor runout. Believe it or not, this pulsation/runout was resolved after performing the bed in procedure and did not recur. I got the performance increase that I sought - the difference was GREAT, even though I did the front pad set only and the car's stopping power was already good. I found that the pads were not really low dust, at least by my interpretation.

Mazda brakes are notoriously shit. They’re garbage. Buy a set of PowerStop brakes and be done with it. They’re far superior to the Mazda brakes. Go on any forum and you’ll see countless people having the same issue as you. New brakes between 15-20,000 miles. Me included. I’ve owned 2 6s from new. Both needed brakes around 20,000 miles. Both times I put on PowerStops and never had another issue.