Shock absorbers KONI or OEM Volkswagen

I have the rear yellows. They're great paired with stock springs. Unfortunately they must be removed to adjust.

I went with the Koni Yellow / H&R spring combo on my 330xi. The handling was great (with a beefier rear sway bar) and the ride was VERY firm. I think the drop *amount* was perfect though.

Those were just replaced with koni yellows and neuspeed sports. I like the ride height with these. I have used these same springs in the past with boge turbogas dampers. The konis certainly ride better and I hope last much longer.

I opted to go w/the following: Golf R springs (euro wagon rears form E-ACCA), Koni Special Actives, Golf R bumpstops. I have about 5K on the setup, and absolutely love it. The tire-to-wheel cap is around 38mm front and rear, and there's very little sag with a loaded boot.

Based on the information learned from 40+ pages of reading in that thread, I just installed Koni Yellows and Neuspeed Sport springs on mine. It is now a totally different car. I had been running stock dampers with VWR springs for the last 3 years (zero improvement in handling with VWR springs by the way). The konis are damped / valved nice and taut without being harsh.

Currently running KONI yellow shocks and he sport springs, all poly bushings in the rear, Rs3 and TTRS in the front. Also running Passat spindles and control arms and a rear sway bar from Neuspeed with a UM haldex tune. My car weighs 3000lbs and I can tell you it is about as good as it gets handling wise.

Now on the shocks: Before I cut the bump stops, the car would frequently bottom out on the rears, so they weren't really able to do any work. Afterwards though, she smooth. I'll still feel bumps and holes through the chassis from the springs and hear the tires going over cracks, but I don't really feel the cracks quite as much. Train tracks that used to rock the wheels are more floaty and smooth now.

Well got the Bus back from the shop. Among other things we got the following done.. -New shocks Bus runs quite nicely now.

I installed a pair of Koni Special Actives in the rear, but didn't have time to do the front yet. Initial impressions (remembering that I only have the Koni installed in the rear): - Compression damping feels about the same as what I remember newer OEM valving feels like. - Hitting small to medium bumps feels pretty good. It's firm but still controlled. Probably a little better than stock. - In low-frequency mode there is a little too much rebound damping. I noticed this when driving past expansion joints on the freeway that form a /\\ shaped ramp. The rear feels like it's being picked up and then dropped. It's subtle though. - In high-frequency mode there might be too little rebound damping. I noticed this when corning hard on smooth roads with occasional rough patches. The Tiguan tilts a little more than I would have expected. But since my front dampers are still worn this really isn't a fair evaluation yet (roll couple is way off). I'm not sure what I feel about the FSD valving yet. The change in valving from the FSD is a little "weird" if I'm paying attention to it. I would say that there is a touch too much rebound, but that gives the impression of sportiness. I think for most people these would be pretty good dampers. They feel sporty but still handle bumps well.

I have Koni Red's on my Jetta, on the stock setting they come in they feel just a bit stiffer then the stock sport suspension that came on the car. I like them. After several years they are rusting a bit though.