Headlights Osram or TYC

I’ve got a pair on my mk6 tsi Just to answer you questions a bit quick:

1. Definitely, but you might need to swap the bulbs to LED as the ones I ordered came without. It gives a much better light than the original headlights.

I've swapped headlights and retrofitted on every car i've owned, mostly to HID's but for this car I went with the OSRAM's from europe. Yes, it's a little more expensive, but the performance and easy install was worth it for me.

Bought some TYC replacements for my 4th gen a few years back. They’ve held up well

TYCs still rocking without any moisture two years later.

I’ve used TYC many times and no issues to report.

I believe I have these on my S70 and they've lasted several years now with no visible clouding or any issues whatsoever. Good buy imo.

These are hands down best upgrade for stock halogen headlights. Plug & play - no coding or pinning required.

I’ve got TYC headlights on my V50. It all works and fits but the quality is definitely lower than oem, but it works and its a lot cheaper so its worth it if you are on a budget. Would go oem next time though

it's been driving me nuts that I've been getting condensation only in my passenger side headlight. They're brand new TYC aftermarket headlights and I have another friend with the same exact issue. Same brand, same side.

It's not leaking or anything. Just your typical condensation that doesn't go away lol. I've checked the breather valve (valve for venting the heat) and while it looks identical to the driver side, the holes are pretty small. I'm guessing it's not enough for the hot air to vent out, hence the condensation.

First picture is low beams Second high and low Third against a wall about 10 feet away ( couldnt find a dark enough place with enough space to do the 25ft) My main complaint is the dark and hot spots. There is no blend with the beams. You can clearly see the reflectors mirrored onto the street. (Worse in real life) Also there is no light thrown to the sides of the vehicle. Almost looks like a spot light They might not be adjusted perfectly but that is also due to the lack of quality. While adjusting the headlights one of 6mm hex screws came out. Another one appeared to not to be doing anything and then jumped a large amount and stopped adjusting. Im assuming they skipped a tooth or the internal adjusting screw came out of the reflector housing.