Engine oil VALVOLINE or Lucas

I was skeptical of this oil until I saw some actual results and a few oil analysis. Whatever this special carbon eating molecular structure they have come up with works and isn't damaging to parts. I'm at about 29K miles and just put this oil on the VB.

Valvoline VR 1 straight 40

Change the oil and filter then I use valvoline vr1 10w30. Remember vw engines rely on oil flow, not heavy viscosity.

Valvoline MaxLife 10W40. Made specifically for older engines with high mileage.

I just did the restore and protect on my 2015 and let me tell you that it has made a massive improvement. Immediately the engine runs quieter and smoother and after 500km it’s like my engine has much more power.

I think that as a general rule you want a motorcycle specific oil in your primary because of specific additives in it for a wet motorcycle clutch. Just don't use a super slick oil like the Valvoline VR1 Racing blue sapphire stuff.

I recommend valvoline syn power mst C3 for Renault diesel engines with dpf filter. Low saps oil which will produce less carbon in your engine. I have 110hp version of 1.5dci and use this oil for last 6 years. Never had a problem and oil consumption is minimal

Valvoline is really good and proves it on tests. Available at any auto parts store... currently running it in a westinghouse 2550dfc

I run Valvoline VR1 20W-50. I believe during cooler seasons you can run a thinner (less viscous) oil.

I have run the 5w-40 and stuff every day here in utah and it works fine on 300-400 bhp setups. If you are going to the strip or the dyno and going for probably 450-500 crank I would probably grab that gold top mobil one 15w-50. I would also use that for any road racing where the engine oil gets really thinned out from heat. It's also cheap at wal mart I believe. Over at 575-600 bhp we lost a main bearing when doing endurance testing on valve springs with the 5w-40 and very reasonable oil temps. It didn't really catastrophically fail, but was on it's way to it when we tore it down. Have since switched to VR1 20w-50, and the problem so far appears to be cured. That stuff will carry way more load then the thinner oils- the catch is that it's absolute sludge until warmed up. Yet another one of the barriers to extreme power "street" cars I suppose. I'm keeping an eye on it to see if we have a solution. If that doesn't fix it, the problem may be aeration of the oil- we were running at 7500+ for pretty long periods. So basically now the oiling system is a major focus of R&D for us. The oil pressure was never out of the ordinary- although it does start falling once past about 7500 rpms which is also not great.